Enter your bodyweight and your total. The calculator returns your Wilks score and your DOTS score side by side, with the formula and coefficients printed below so you can check the arithmetic. It works in kilograms or pounds, needs no account, and sends nothing anywhere.
Enter either the three lifts or the total. If you fill in all three lifts, they are added and the total field is ignored.
Fire Your Coach logs every set that builds the total, so when you come back here after a block you are entering numbers you can trace. The calculator stays free either way.
score = total (kg) × 500 ÷ (a + b·x + c·x² + d·x³ + e·x⁴ [+ f·x⁵])
Here x is bodyweight in kilograms. Wilks uses all six terms, DOTS stops at x⁴. A 500 in the numerator scales the result so that a typical strong lifter lands in the low hundreds. The calculator on this page runs exactly these lines.
| Term | Wilks, male | Wilks, female | DOTS, male | DOTS, female |
|---|---|---|---|---|
| a | -216.0475144 | 594.31747775582 | -307.75076 | -57.96288 |
| b | 16.2606339 | -27.23842536447 | 24.0900756 | 13.6175032 |
| c | -0.002388645 | 0.82112226871 | -0.1918759221 | -0.1126655495 |
| d | -0.00113732 | -0.00930733913 | 0.0007391293 | 0.0005158568 |
| e | 0.00000701863 | 0.00004731582 | -0.000001093 | -0.0000010706 |
| f | -0.00000001291 | -0.00000009054 | not used | not used |
Coefficients as published in the open powerlifting-formula references and implemented in common calculators. We did not derive them. If a federation publishes a different revision, trust the federation.
A 500 kg total means something different at 70 kg bodyweight and at 120 kg. The coefficient is an attempt to put both on one line. It is a fitted curve, which makes it a convention rather than a measurement, and the two conventions on this page give different numbers for the same lifter.
That is the useful part. Put your numbers in and look at the gap between Wilks and DOTS. Near middle bodyweights it is small. Toward the ends of the range it widens, and neither is the truth. Pick one and keep it, the same way you would keep one estimated-max formula, so the trend across blocks measures your training and not your choice of curve.
It is also built for the three powerlifts. It says nothing about a Hyrox finish time, a ruck or a 5k, and if you train for both, a total scored per kilo is only half the picture. The other half lives in a different log.
A 90 kg man with a 500 kg total. Wilks: the polynomial at 90 kg comes to about 783.2, so the score is 500 × 500 ÷ 783.2, close to 319. DOTS: the polynomial at 90 kg comes to about 773.3, so the score is about 323. Three or four points apart on the same lifter.
There is no official threshold, and any number we printed would be a guess dressed as a fact. What the score is good for is comparing yourself with yourself: same formula, a total that moves up over a program. Compare your score from one block to the next rather than against a table.
Both multiply your total by a coefficient that depends on bodyweight and sex. Wilks uses a fifth-degree polynomial, DOTS a fourth-degree one with different coefficients. They disagree most at the light and heavy ends of the bodyweight range and agree closely in the middle. This page shows both so you can see the size of the gap for your own numbers.
Enter the total: your best squat, bench press and deadlift added together. The calculator has a field for each lift and adds them, or you can use the single total field. If you only have estimated maxes from training, the result is an estimate too.
Yes. Pick lb and enter bodyweight and lifts in pounds. The page converts to kilograms (divide by 2.20462) before applying the formula, because both Wilks and DOTS are defined in kilograms. The score itself has no unit.
Fire Your Coach does not file a Wilks or DOTS score. It keeps the sets, loads, reps and estimated maxes behind the total, so you can enter fresh numbers here after each block and see the trend.
Every working set you log feeds the next program, so the total you score here is the end of a record rather than a guess.